GE Washer Continuous Water Fill & Water Inlet Valve Replacement in National City
A resident near the Mile of Cars district in National City contacted ETS Appliance Repair with an urgent laundry emergency. Water was continuously trickling into the tub of their GE washing machine, even when the appliance was turned completely off, risking a laundry room floor overflow.
Initial field diagnostic checking incoming water supply lines and valve solenoids.
Our master technician arrived at the National City home within our 2-hour dispatch window to perform a systematic diagnostic:
- 1Power Isolation & Leak Test: Shut off electrical power to the washer. Water continued to trickle into the drum, confirming a mechanical valve diaphragm failure rather than an electronic control board signal error.
- 2Water Inlet Valve Inspection: Unmounted the top panel to access the GE dual water inlet valve assembly. Hard water mineral deposits and degraded internal rubber solenoid diaphragms prevented the valve seals from closing fully under line pressure.
Unmounting the failed water valve solenoids and installing a brand-new factory OEM GE water inlet valve.
After explaining the diagnosis, the customer approved replacing the water valve assembly:
- Water Supply Shut-Off: Isolated hot and cold water supply valves and depressurized hoses.
- OEM Valve Installation: Replaced the failing valve body with a genuine factory OEM GE dual-solenoid water inlet valve.
- Hose Connection & Pressure Check: Reattached braided fill hoses with new rubber washers and verified 100% leak-free threaded connections.
With the new GE water valve installed, our technician executed thorough fill and shut-off verification:
- Fill Verification: Started warm, hot, and cold fill cycles—solenoid coils opened cleanly.
- Shut-off Test: Paused cycle and powered off washer—water shut off instantly without a single drip.
- Tub Water Level Calibration: Verified pressure switch sensor cycling correctly.
Final operational test confirming instant automatic water shut-off and perfect wash performance.
We believe in 100% upfront pricing with zero hidden charges:
- Diagnostic Visit & Inspection: $99.95 *(100% FREE & Waived with completed repair)*
- Genuine OEM GE Water Inlet Valve & Replacement Labor: $365.00
- Total Investment: $365.00
- Warranty Included: 90-Day Parts & Labor Warranty
If you hear a quiet hissing sound or see water trickling into your washer drum when it is turned off, turn off the wall water supply valves immediately. Replacing a faulty water inlet valve early prevents costly home water damage and high utility bills.
Need Technician Assistance Today?
$99.95 Technician Diagnostic Visit • 100% Waived With Completed Repair.
More Articles & Troubleshooting Guides
Kenmore Dryer Squeaking Loudly: Complete Drum Support Roller & Idler Pulley Rebuild in Clairemont
Clairemont service call: A Kenmore front-load dryer was producing an ear-splitting squeal while tumbling. We pulled the drum, diagnosed flattened roller bearings and a seized idler pulley, and installed a full heavy-duty roller rebuild kit.
Rheem AC Outside Unit Not Turning On: Universal Dual Run Capacitor Replacement in Poway
Poway HVAC service call: A Rheem outdoor central AC condenser hummed loudly but refused to spin during a heatwave. We discharged the electrical cabinet, diagnosed a dead dual run capacitor, and custom-configured a heavy-duty universal replacement.